7
3. Identify the Right Upright (78) and the Right
Upright Spacer (79), which are marked with
stickers.
Insert the Wire Harness (38) through the Right
Upright Spacer (79) as shown. Then, set the
Right Upright Spacer on the Base (83). Be care-
ful not to pinch the Wire Harness.
Have a second person hold the Right Upright
(78) near the Base (83). See the inset drawing.
Tie the long tie in the Right Upright securely
around the end of the Wire Harness (38). Then,
pull the other end of the long tie until the Wire
Harness is routed completely through the Right
Upright.
83
38
78
79
38
3
2. Attach a Wheel (84) to the Base (83) with a 3/8"
x 2" Bolt (4) and a 3/8" Nut (8). Do not over-
tighten the Nut; the Wheel must turn freely.
83
4
8
2
84
Long
Tie
Long Tie
78
38
1
. Make sure that the power cord is unplugged.
W
ith the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (56) so that the treadmill is more stable;
do not fully fold the Frame yet.
Remove and discard the two indicated bolts (A)
and the shipping bracket (B).
Cut the ties securing the Wire Harness (38) to
the Base (83). Locate the tie in the indicated
hole in the Base, and use the tie to pull the Wire
Harness out of the hole.
Attach a Base Foot (81) to the Base (83) in the
location shown with a Base Foot Spacer (13)
and a #8 x 1" Tek Screw (2). Then, attach an-
other Base Foot (81) with only a #8 x 1" Tek
Screw (2).
83
2
56
81
1
81
2
38
Hole
13
B
A
To Next Page
Loading...
