Reed Instruments LM-8000 - Thermocouple Temperature Measurement; Humidity and Ambient Temperature; Light Level Measurement

8
Thermocouple Temperature Measurement
1. Plug the optional Type K Thermocouple Probe into the thermocouple
input jack.
2. Select the "tP" function (see Selecting Measurement Modes section
for details). In this mode, the LCD display will only show the
thermocouple temperature.
3. Press the °C/°F button to select between °C and °F.
Note: If no thermocouple is connected, the meter will display "-----".
Relative Humidity and Ambient Air Temperature
Measurements
When the meter is introduced into a new environment, it will take a few
minutes to fully stabilize.
1. Select the "rH" function (see Selecting Measurement Modes section
for details). In "rH" mode, the display will show %RH and ambient air
Temperature simultaneously.
2. Press the °C/°F button to select between °C and °F.
Light Measurements
1. Select the "LIgHt" function (see Selecting Measurement Modes
section for details).
2. Press the Lux/Ft-cd button to select Lux or Foot-candle units of
measure.
3. Before taking measurements, a zero offset adjustment should be
performed (see Zero Adjustment section for details).
4. Hold the sensor toward the light source and note reading.
continued...
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com