Reed Instruments R9100 - Transmitter Operation; Battery Replacement Procedure; Product Applications; Product Care and Maintenance

6
1. Turnonthetransmitter.Ifthe"POWER"LEDlightdoesnotlightup,
replacethe9Vbattery(seeBattery Replacement section
fordetails).
2. Place the transmitter inside the compartment under test, then close
the compartment.
3. The ultrasonic sound emitted by the transmitter will pass through any
orice or faulty seal.
4. Scan the outside surface of the compartment with the receiver.
5. The ultrasonic sound escaping from the compartment will be
detected by the receiver.
Battery Replacement
Follow the instructions below to replace the battery on either the receiver
or transmitter.
1. To replace the battery, slide the battery cover open.
2. Replacethe9Vbattery.
3. Secure the battery cover back into place.
Applications
• Verifyingandcheckingforleaksinrefrigerationandair
conditioning systems
• Compressedairsystems
• Engineseals
• Windshields
• Windows
• Doors
Product Care
To keep your instrument in good working order we recommend the following:
• Storeyourproductinaclean,dryplace.
• Changethebatteryasneeded.
• Ifyourinstrumentisn'tbeingusedforaperiodofonemonthorlonger
please remove the battery.
• Cleanyourproductandaccessorieswithbiodegradablecleaner.Donot
spraythecleanerdirectlyontheinstrument.Useonexternalpartsonly.
REED Instruments
1-877-849-2127 | info@reedinstruments.com | www.reedinstruments.com