REED 00 MODEL: C50SS
TRAILER CONCRETE PUMP
MAINT
PAGE 10
SYSTEM MAINTENANCE ITEMS
The following are specific items for care and maintenance of the hydraulic system.
• FLUID LEVEL Check level daily with sight gauge provided.
Maintain level at full mark. Add through filter.
• TANK BREATHER Clean every 50 hours of operation. Remove from
tank, clean with solvent and air blow dry.
• RETURN LINE FILTER One (1) 10-micron filter; change after first 50
Hours of operation. Thereafter change every
150 hours of operation or when condition
gauge indicates to do so.
• HYDRAULIC TANK Change oil in tank every 1000 hours of operation
of yearly whichever comes first.
After fluid loss for any reason, filter replacement,
component removal etc., sufficient fluid must be
added to properly maintain required level in tank.
HYDRAULIC FLUID
The 00 MODEL C50SS utilizes in its hydraulic system a fluid manufactured by the SHELL
OIL CO. and is designated as TELLUS #46. It is to be used in ambient temperatures of 39-
90° F (4-32° C). The normal fluid temperature will range from 100-167° F (38-75° C).
For ambient temperatures of 90° F (32° C) and above use fluid designated as a ISO rating
of 68. Use ISO 32 for ambient temperatures of 32° F (4° C) and below.
USE ONLY SHELL TELLUS 46 or equal hydraulic fluid
and NEVER MIX with other type fluids. Always use a
CLEAN fluid. Using impure or other type of fluids not
specified will contaminate the hydraulic system and
can lead to eventual system malfunction or damage
and possibly deteriorate the hydraulic seals.
REVISION:
To Next Page
Loading...
