Tighten the mount using longer screws (type A) so that the device is at the correct height when standing
or hanging. The water line marked on the device must be level or a maximum of 2 cm above level in the
tank.
If you want to mount the device on legs, screw them according to picture 1. If you want to hang the
device, screw the brackets according to picture 2.
You can use a screwdriver to insert the screws. Pay particular attention to the force
with which the plastic parts are screwed in, so as not to damage them.
Smart roller manual © Reef Factory 2023
5
To Next Page
Loading...
