DF-50 Diffusion Hazer Operation
Page 4 of 10
Manual
DF-50 DIFFUSION
™
™™
™
HAZER
OPERATING
Always
1. Transport the unit right side up or empty.
2. Before operating, fill with Diffusion™ Fog Fluid just below the top of the tank window on the
side of the unit. ALWAYS TAKE CARE NOT TO OVERFILL.
3. Check the machine for correct voltage.
4. Check the female plug for tight connection before plugging the male end into an AC
voltage receptacle. DC voltage will result in damage to the machine.
5. If the circuit breaker trips, turn OFF the machine and reset by depressing the breaker button,
then turn back ON. Be sure to plug directly into a wall outlet or use a 2.5mm
2
extension cord.
Note: When starting the voltage must not drop below 200 volts (220v units only). If it continues to
trip contact your dealer.
6. The machine must be level to operate properly.
7. The machine holds 2 liter’s or 1/2 gallon of fluid. DO NOT OVERFILL. If you overfill, then it
may be necessary to remove the cover to clean-up the excess fluid.
FILLING INSTRUCTIONS
1. Unscrew the cap on the top of the unit and pour fluid into the opening. Be careful not to overfill.
2. Do not use more than 2 liter’s or 1/2 gallon of fluid.
3. Check the level by using the sight window on the side of the unit.
4. If overfilled, empty excess by tipping to the side and pouring back out of the spout. If you have
spilled fluid inside the machine it may be necessary to remove the cover to clean-up the excess
fluid. If this is required DISCONNECT the machine from the power supply before opening.
CAUTION
Only Diffusion™
™™
™ Fog Fluid may be used in the operation of the DF50. Any other fluid may clog
the machine, cause sever damage and will void the manufacturers warranty coverage.
DO NOT ATTEMPT TO SERVICE THE DF-50
CALL YOUR DEALER IF YOU HAVE ANY QUESTIONS
To Next Page
Loading...