Reel EFX Diffusion DF-50 - Useful Tips

DF-50 Diffusion Hazer Operation Page 6 of 10
Manual
DF-50 DIFFUSION ™
™™
™ HAZER
USEFUL TIPS
The DF-50 Diffusion™ Hazer provides a fine atmospheric mist. The recommended level for use in
an eight hour day is 5mg/CuM, and this represents a fine mist, NOT fog or smoke. When this mist
is just visible to the eye, then you would have maximum working concentration.
♦ Always use Diffusion™ Fog Fluid. Operation with any other fluid will invalidate the warranty
and fail to meet CAL/OSHA tested standards.
♦ If required, you may use an “RE’ Fan or other type of fan to disperse the mist produced, but it
is not recommended to mist through the fan as this will result in build-up on the fan blades.
♦ It is NOT necessary to place the unit where mist is required as the DF-50 will provide an even
amount of atmospheric ambiance.
♦ Do not leave the machine ON continuously in a small room as this will result in too high a
concentration and may leave unwanted residue.
♦ DO NOT block the supply of air to the back of the unit as you will prevent the compressor from
performing efficiently and may overheat the compressor.