DF-50 Diffusion Hazer Operation
Page 5 of 10
Manual
DF-50 DIFFUSION
™
™™
™
HAZER
ROUTINE MAINTENANCE
FLUID LEVEL: Using the glass sight level on the side of the machine fill with a sufficient amount
of fluid to approximately 1/2” below the top level. If you overfill, then tip the machine on its side to
dispose of the excess.
COMPRESSOR: No maintenance is required and no attempt should be made to service the
compressor. The compressor is rated at MTBF 5000+ hours before any rebuild may be
necessary.
AIR FILTER: Remove top of the black filter element. By twisting counter clockwise ¼ turn.
Remove wool element and was in soap and water, then reassemble.
WATER TRAP: To maintain maximum filtering efficiency and to avoid excessive pressure drop,
the filter must be kept clean. To access the filter you need to remove the cover of the DF-50.
Turn the drain valve to remove any bowl accumulation before it reaches level of lower baffle. A
visible coating of dirt or condesate on the filter element or excessive pressure drop indicates
cleaning is necessary.
To clean, depressurize air line and remove bowl. Wash filter elements with household soap.
Elements should be replaced if soiled or creating excessive pressure drop. Blow out body with
compressed air. Clean bowl only with household soap.
TANK: No maintenance is required and no attempt should be made to service.
If any problems occur, you should contact your dealer
To Next Page
Loading...