35
Pull out the landing gear downwards and press the corresponding holes when installing.
When replacing the receiver, remove the double-sided tape together, align the new receiver with the edge of
the rack and stick it tightly without skewing, and then connect the servo and the motor in the order of the plugs.
Pulloutthebiggearstraightdown,payattentiontothedirectionwheninstallingthenewgear,andtheaxisplane
should be aligned with the plane of the inner hole of the gear.
When removing and replacing the tail rotor, please pay attention to the direction, align the motor shaft and press
it slowly to ensure smooth rotation.
To Next Page
Loading...
