Reflex REFLEXOMAT RG - Page 15

15
kUHǘH[GH___5HǘH[RPDW5*5)
EN
5HǘH[RPDWYHVVHOVDQGSUHVVXUHHTXLSPHQW
3UHVVXUH(TXLSPHQW'LUHFWLYH(8
These instructions describe the assembly of the primary
YHVVHODQGWKHRSWLRQDO5HǘH[RPDWVHFRQGDU\YHVVHO
8VDJHLVH[FOXVLYHO\LQFRPELQDWLRQZLWKWKH5HǘH[RPDW
control unit. In addition to these instructions, refer to the
RSHUDWLQJLQVWUXFWLRQVIRUWKH5HǘH[RPDWVVXSSOLHGZLWK
the control unit.
Importance of documentation:
Carefully read and follow the instructions before assembly,
commissioning, operation or maintenance! Always pass the
instructions on to the current system operator and save them
for later use!
Note:
The vessels must only be assembled, commissioned and
PDLQWDLQHGE\VNLOOHGTXDOLǗHGVSHFLDOLVWV
Warnings:
Observe and comply with the warnings in these instructions.
,GHQWLǗFDWLRQRILPSRUWDQWZDUQLQJV
Warning. Dangers that can result in severe and/or
fatal injuries.
Caution. Dangers that can result in injuries or health
risks.
Attention. Dangers that can result in damage to the
system or malfunctions.
Note. Supplementary notes or information.
General safety instructions:
• National standards and regulations for the operation of
pressure equipment, as well as for accident prevention, are to
be given priority and must be followed.
• Risk of scalding from hot surfaces, hot water or hot steam.
• Before working on the system, depressurise it and let it cool
down. Make sure that the pressure equipment is
depressurised before starting work.
Ɔ7KHRSHUDWLQJSUHVVXUH36PXVWQRWIDOOEHORZH[FHHGWKH
PLQPD[SHUPLVVLEOHYDOXHV7KHPLQPD[SHUPLVVLEOH
RSHUDWLQJWHPSHUDWXUH76PXVWEHREVHUYHG
• When replacing parts, use only genuine spare parts from the
manufacturer.
Safety instructions for assembly and setup:
• Local occupational health and safety measures are to be
given priority and followed.
• The vessels are heavy. Use suitable lifting equipment for
transportation and assembly.
Ɔ$YRLGH[SRVLQJWKHSUHVVXUHHTXLSPHQWWRDQ\LPSHUPLVVLEOH
forces during transport and setup.
Ɔ8VHWKHIDFWRU\ǗWWHGVXVSHQVLRQSRLQWVIRUVHWXSLISUHVHQW
Ɔ(QVXUHWKDWWKHLQVWDOODWLRQVXUIDFHRIIHUVVXIǗFLHQWVWDELOLW\
DQGORDGEHDULQJFDSDFLW\WDNLQJLQWRDFFRXQWWKHPD[LPXP
ǗOOOHYHORIWKHYHVVHO
• The design does not take into account transverse or
longitudinal acceleration forces.
• The pipe connections must be force-free and torque-free
and the pipes must be laid in a vibration-free manner.
If you have any questions, please contact
5HǘH[$IWHU6DOHV6HUYLFH
• The installation location must be a closed-off, dry and
frost-free room.
Ɔ7KHLQVWDOODWLRQORFDWLRQPXVWEHSURWHFWHGDJDLQVWǘRRGLQJ
• Install so that inspection is possible from all sides, the level
measurement function is guaranteed and the type label
remains visible.
Proper use:
7KH5HǘH[RPDWYHVVHOVPD\EHRSHUDWHGRQO\LQFRQMXQFWLRQ
ZLWKWKH5HǘH[RPDWV
6HHRSHUDWLQJLQVWUXFWLRQVIRU5HǘH[RPDW
Liability:
No warranty or liability in cases of
• Failure to heed these instructions
• Incorrect installation and/or operation
• Installation and/or operation of a faulty product
Ɔ8QDXWKRULVHGPRGLǗFDWLRQVWRWKHSURGXFW
Maintenance:
6HHRSHUDWLQJLQVWUXFWLRQVIRU5HǘH[RPDW
Testing:
Pressure equipment is subject to mandatory testing. The
RSHUDWRULQGLYLGXDOO\GHǗQHVWKHWHVWLQWHUYDOVEDVHGRQWKH
national regulations and a safety-relevant evaluation, and
with due consideration for the actual operating conditions.
Disposal:
Observe the local regulations for recycling or waste disposal.
The product may not be disposed of with normal household
refuse and must always be disposed of in the correct way.
Standards to be considered:
• Heating systems in buildings DIN EN 12828
Ɔ,QGXVWULDO6DIHW\'LUHFWLYHIRU*HUPDQ\ż\RXFDQǗQG
information about this on our homepage)
Applied directives:
• Pressure Equipment Directive 2014/68/EU
 )RUVHOHFWHGWHFKQLFDOVSHFLǗFDWLRQVVHHW\SHODEHO
Safety instructions