REFU 801 Series - Page 7

REFUone 3K-2T …7K-2T
7
1.1.5 Operation
Touching the electrical grid or the terminal of the equipment may lead to
electrocution or fire!
 Don’t touch the terminal or conductor connected to the electrical grid.
 Pay attention to any instructions or safety documents related to grid
connection.
Danger
Some internal components will be very hot when inverter is working.
Please wear protective gloves!
Attention
1.1.6 Maintenance and repair
 Before any repair work, turn OFF the AC circuit breaker between the
inverter and electrical grid first, then turn OFF the DC switch.
 After turning OFF the AC circuit breaker and DC switch, wait for 5
minutes at least before carrying out any maintenance or repair work.
Danger
 Inverter should work again after removing any faults. If you need any
repair work, please contact with the local authorized service center;
 Can’t open the internal components of inverter without authorized.
REFU Elektronik GmbH does not take any responsibility for the losses
from that.
Attention
1.1.7 EMC / noise level of inverter
Electromagnetic compatibility (EMC) refers to that one electrical equipment functions in a
given electromagnetic environment without any trouble or error, and impose no unacceptable
effect upon the environment. Therefore, EMC represents the quality characters of an electrical
equipment.
 The inherent noise-immune character: immunity to internal electrical noise.
 External noise immunity: immunity to electromagnetic noise of external system
 Noise emission level: influence of electromagnetic emission upon environment.
Electromagnetic radiation from inverter may be harmful to health!
Please do not continue to stay around the inverter in less than 20 cm when
inverter is working.
Danger