How to fix PM isolation LT error on REFU Inverter?
If your REFU Inverter shows a PM isolation LT error, it means the power section detects an isolation error on activation. Check system isolation. If you consider the isolation resistance to be in order, contact Service.
What does Keep Alive mean on REFU REFUsol 10K Inverter?
If your REFU Inverter displays Keep Alive error, it means internal communication monitoring has determined a fault. Please contact Service.
What to do if REFU REFUsol 10K displays SR parameter error?
If your REFU Inverter displays an SR parameter error, it signifies an error in parameter initialization, and the device has been permanently shut down. Please contact Service.
What to do if REFU REFUsol 10K Inverter showing update fault?
If your REFU Inverter displays an update fault, it means the update has failed. Contact Service.
What to do if REFU REFUsol 10K shows Supply voltage LT error?
If your REFU Inverter displays a Supply voltage LT error, it means the supply voltage at the power section is too low. Please contact Service.
What does Activation LT 4 mean on REFU Inverter?
If your REFU Inverter displays Activation LT 4 error, it means balancing has failed. Please contact Service.
How to resolve Initialisation C1 error on REFU REFUsol 10K?
If your REFU Inverter displays an Initialisation C1 error, restart the inverter. If this does not rectify the error, contact Service.
What to do if REFU REFUsol 10K Inverter shows DC-voltage measurement error?
If your REFU Inverter displays a DC-voltage measurement error (DC link 3), wait for the measurements to become stable again. If this takes more than 2-3 hours, please contact Service.
What does Communication LT mean on REFU REFUsol 10K?
If your REFU Inverter shows Communication LT error, it means there is a communication malfunction between the power section and the control and regulation unit. The inverter will acknowledge the error automatically. If the problem occurs repeatedly, contact Service.
What to do if REFU Inverter shows RCD fault?
If the AFI-Board unit in your REFU Inverter detects a residual current, it will lead to an immediate shutdown. Check the system isolation. If you believe the isolation impedance is fine, contact Service.
Describes the designated use of the REFUsol inverter.
Specifies the required qualifications for personnel working with the inverter.
Lists potential dangers and risks associated with improper use of the inverter.
Details safety measures to prevent contact with electrical components.
Advises on precautions to avoid burns from hot surfaces.
Outlines safety measures for handling and assembling the inverter.
Lists essential checks and conditions before initial startup.
Details the DC connection points and procedures for the inverter.
Specifies the environmental and safety requirements for the inverter installation location.
Provides instructions for mounting and installing the inverter.
Describes the various connectors available on the inverter unit.
Explains the importance and procedure for grounding the inverter.
Details requirements for residual current protection devices.
Provides instructions for connecting the inverter to the power supply.
Covers specifications and guidelines for the power supply line connection.
Explains how to connect the PV generator to the inverter.
Provides detailed information on DC connection types and components.
Guides on connecting the SUNCLIX connector.
Step-by-step guide for powering on the inverter.
Instructions for initial configuration of country code and language.
How to select the country code and grid guideline parameters.
Describes the startup procedure and status indicators after commissioning.
How to configure a limit for the inverter's power output.
Guide on connecting to and using the REFUlog monitoring portal.
To Next Page
General
