Rega P2 - Introduction; Unpacking your turntable

Turntable contents
1. Platter
2. Drive belt / pulley (underneath platter)
3. Tonearm
4. Balance weight
5. Plinth
6. Power input (underside of the turntable)
7. Phono output (rear of the tonearm)
8. On / off switch (underneath plinth)
230 V AC 50 Hz 40 mA
24 V AC 100 mA AC
230 V AC 50 Hz 40 mA
24 V AC 100 mA AC
115 V AC 60 Hz 90 mA
24 V AC 100 mA AC
220 V AC 60 Hz 40 mA
24 V AC 100 mA AC
100 V AC 50/60 Hz 100 mA
24 V AC 100 mA AC
230 V AC 50 Hz 40 mA
24 V AC 100 mA AC
PS2 (UK)
Input
Output
PS2 (Australian)
Input
Output
PS2 (UL - American)
Input
Output
PS2 (Korean)
Input
Output
PS2 (Japan)
Input
Output
PS2 (EU - Euro 2 pin)
Input
Output
Warning
Only use the supplied Rega PS2 mains adaptor with
this product.
1
ENGLISH
Introduction
Please follow this quick set-up guide to ensure optimum
performance and perfect operation. Failure to do so may
invalidate your warranty. For more information on this
product, please visit www.rega.co.uk.
Unpacking your turntable

Follow the packing guide printed inside the front of
the box.
Save the packaging in case you need to transport
your turntable in the future.
Place your turntable on a rigid level surface.
Ensure the drive belt is in place and remove the
transport hub card from beneath the sub platter.

turntable mat.