IN USE
Once powered, the display will show Saturn-R. The player will remember which
mode it was previously used in (either CD or DAC). For example, if the unit was
powered off whilst in DAC mode, it will begin in DAC mode and re-call the previous
input when powered up. If in CD mode, the player will attempt to initialise a disc
automatically. If no disc is present, the player will show ‘NO DISC’. Manually lift the
lid and then ‘DOOR OPEN’ will be displayed. Carefully place the disc on the ball
chuck and close the lid. The player will initialise the disc. Once completed, it will
display the total number of tracks and total time of the disc. Press PLAY and the
first track of the album or single will begin.
If DAC mode is selected via the Solaris remote control, the chosen input is
illuminated via the display. Inputs 1 through 5 are displayed via the CD calendar (See
below). If an incoming frequency is detected, the display will show the incoming
sample frequency and which filter is selected. If no input is connected, ‘DAC NO
INPUT’ is displayed.
The Saturn-R will only display the following : 44/48K - 88/96K - 176K or 192K.
7
Incoming frequency Selected filter Input
192K F i l 3
1. 2. 3. 4. 5.
To Next Page
Loading...
Need help?
General
