Using Fresh Water System With Tank Only
This approach is mainly used while cruising without the
ability to draw from a marina or public water supply by
attaching a garden hose to the city water valve. Also, use
this procedure when you are unsure of the purity and /
or source of the water supply for drinking.
1. Verify through the monitor panel that the fresh water
tank is full by activating the upper portion of the toggle
switch.
2. At the helm switch panel activate the fresh water
system switch. This will energize the water pressure
pump to send fresh water from the potable water tank
through the cold water lines terminating at the various
faucets and related components.
3. Open a faucet. Water pressure should be present.
Opening the faucet for a few seconds will purge any air in
the system especially in cases where the fresh water tank
has run out of water. When water is running at a faucet
it is not unusual to hear the water pump activate as it is
trying to build up the pressure required in the system.
Soon after the faucet is turned off the fresh water pump
sound will end indicating the fresh water system is now
up to specifi ed system pressure.
Note not to run pressure water pump with system dry
as water pump component damage may occur.
PREVENT PROPERTY DAMAGE!
DISCONNECT
THE DOCK SIDE WATER INLET HOSE
BEFORE LEAVING THE VESSEL.
CAUTION
98
-Newer Vessels
To Next Page
Loading...
