INT-13
Introduction
Obtain a current weather report.
Inspect the hull and propeller for damage.
Check all electrical system switches for proper operation.
If your boat has been in the water, run the bilge pump until
the fl ow of water stops.
If your boat has been out of the water, check to see that all
bilge water has drained out. Install the drain plug.
Check that all required safety equipment is on board and in
good working condition.
Check that all other equipment is on board such as mooring
lines, fi rst aid kit, tool kit and extra parts.
Open engine compartment. Inspect for fuel odors and visible
leaks in the fuel, oil, exhaust & power steering systems.
Visually inspect engine for cracked hoses, defective belts,
loose fasteners such as bolts, nuts and hose clamps.
Check fuel level. Fuel tanks should be fi lled to near full
capacity.
Make sure all navigation charts, equipment and vessel
registration paperwork are onboard.
Check operation of bilge blower, steering system, navigation
lights and horn.
Make sure passengers and crew know how to operate safety
equipment and react to an emergency.
File a fl oat plan with a responsible party ashore.
LAUNCH & CRUISE CHECKLIST
To Next Page
Loading...
Need help?
General
