Why is my Regal 38 EXPRESS battery not charging when the engine is running?
If the battery in your Regal Boat is not charging while the engine is running, check for a loose belt and tighten it. If the belt is tight, the alternator may be faulty and needs repair or replacement. A faulty volt meter can also cause this issue, so replace the volt meter.
What to do if the pump in my Regal Boat will not run?
If the pump in your Regal Boat will not run, first check the DC breaker to ensure it has power. Then, inspect the wires at the pump, vacuum generator, and vacuum switch (B terminal connector) for any loose or broken connections. If the wiring is intact, the motor may be faulty and need replacement.
Why is there no DC power in my Regal 38 EXPRESS Boat?
If you have no DC (12 volt) power on your Regal Boat, ensure the battery switch is in the “on” position. If it is, the battery may be weak or dead and needs to be charged or replaced.
What causes poor performance in a Regal 38 EXPRESS?
If you are experiencing poor performance with your Regal Boat, try adjusting the trim, or adjusting the load if it's unbalanced. If these steps don't resolve the issue, there may be an engine problem, and you should call an authorized Regal/Volvo dealer.
How to troubleshoot excessive vibration on a Regal Boat?
If you are experiencing excessive vibration in your Regal Boat, first check for any material obstructing the propeller and use reverse engines to remove it. If the vibration persists, it could be due to a bent drive propeller shaft, in which case you should contact an authorized Regal/Volvo dealer. Other potential causes include a bent propeller blade (repair or replace the propeller), a noisy drive bearing (repair the drive unit), or a damaged drive casting (replace the damaged casting).
Why is the engine speed low on my Regal 38 EXPRESS?
If your Regal Boat's engine speed or RPM is low, the hull may have growth that needs to be cleaned by hoisting the vessel. It could also be due to poor quality fuel, so you should call an authorized Regal/Volvo dealer. Another cause may be accumulation of bilge water, so check for leaks. Finally, the trim tab may be in the “up” position, so check trim tab functions and pump fluid levels.
What to do if there's no power to AC outlets in my Regal Boat?
If you have no power to the AC outlets or equipment on your Regal Boat, start by resetting or activating the main AC ship’s panel breakers if they have tripped or are in the “off” position. Ensure the shore power cord is properly connected. Check for tripped GFCI outlets and reset them, after identifying and resolving the cause of the trip.
How to restore AC power on my Regal Boat?
To restore AC power to your Regal Boat, begin by checking the main shore power breakers to ensure they are energized and not tripped or in the “off” position. Verify that the dock power is activated. Confirm that the shore power cord is securely connected and locked. If there's a faulty connection, repair it. Be aware of potential marina dockside power outages due to transformer malfunction. Also, check and reset the shore inlet breaker if it has tripped.
Explanation of navigation rules for avoiding collisions and their application.
Details on right-of-way rules for vessels to prevent collisions.
Introduction to the basic fuel system components and their function.
Introduction to the vessel's DC and AC electrical systems.
Description of the onboard head system and its operation.
Essential safety tips and warnings for operating the windlass.
Steps to activate the vessel's electronics system.
Introduction to the vessel's propulsion system and engine manuals.
Procedures and importance of the engine break-in period for longevity.
A checklist of essential checks before starting the engines.
To Next Page
General
