What to do if there's water to the pump but no output on my Regal Boat?
If there is water to the pump but no output on your Regal Boat, it may be due to a faulty fresh water pump or pressure switch. Replace the fresh water pump or pressure switch.
What to do if there is no power to AC outlets on my Regal Boat?
If you have no power to AC outlets or equipment on your Regal Boat, first reset or activate the main breakers on the AC ship’s panel. Ensure the shore power cord is properly connected. Also, check for tripped GFCIs and reset them after identifying and resolving the cause of the trip.
What to do if the refrigerator on my Regal 42 Fly-Grande Coupe Boat is not cold?
If your Regal Boat's refrigerator isn't cold, start by ensuring the compressor is running by turning on the breaker at the main ship’s service panel. Check the thermostat setting and the on/off switch, adjusting or activating as needed. Inspect the door latch and seal, adjusting or replacing them if they're not closing properly. Clean the condenser coils to remove any accumulated dirt. If the compressor starts but the fridge doesn't cool, it is recommended to contact a repair professional.
Why is the engine speed low on my Regal 42 Fly-Grande Coupe Boat?
If the engine speed or RPM is low on your Regal Boat, start by hoisting the vessel and cleaning the bottom to remove any growth on the hull. Check the air filters and ventilation system to ensure there is sufficient air supply to the engine. Inspect for any accumulation of bilge water and check for leaks. Also, verify the trim tab is not in the “up” position and check the trim tab functions and pump fluid levels.
What causes excessive vibration on my Regal 42 Fly-Grande Coupe Boat?
If you experience excessive vibration on your Regal Boat, first reverse the engines to remove any material obstructing the propeller. If the vibration persists, it could be due to a bent drive propeller shaft (in this case, contact an authorized Regal/Volvo dealer), a bent propeller blade (repair or replace the propeller), a noisy drive bearing (repair the drive unit), or a damaged drive casting (replace the damaged casting).
What causes nuisance tripping of the main ELCI on my Regal 42 Fly-Grande Coupe?
If the main ELCI on your Regal Boat is tripping, it could be due to a component causing excessive draw. The suggested solution is to repair or replace the part and then reset the ELCI.
Why is there no reading on the gauge of my Regal 42 Fly-Grande Coupe Boat, or why does the gauge read wrong?
If there is no reading on the gauge or the gauge reads wrong on your Regal Boat, it may be due to a faulty gauge (replace the gauge), faulty wiring to the gauge (inspect/repair the wiring), or a faulty sender (replace the sender).
What to do if my Regal 42 Fly-Grande Coupe is not running on DC?
If your Regal Boat is not running on DC, check for a defective thermostat or converter, or a low battery. Replace the thermostat, converter, or battery as needed.
Why won't the battery hold a charge on my Regal 42 Fly-Grande Coupe?
If the battery on your Regal Boat will not hold a charge, it is likely due to a faulty or old battery. Replace the battery with an exact replacement.
What causes poor performance on a Regal 42 Fly-Grande Coupe?
If you experience poor performance with your Regal Boat, adjust the trim, adjust the load if it’s unbalanced, or there could be an engine problem. If it is an engine problem, call an authorized Regal/Volvo dealer.
To Next Page
General
