English 7
STEP 1
Locate the (4) threaded
spindle rods. Rotate the
adjustment wheels along
the threading, eliminating the
gap between the adjustment
wheel and the rubber foot.
NOTE: You will notice a slight gap between the gate door latch and the
frame. This is not a defect. Your gate is a pressure mounted gate and this
gap will disappear once you tighten your gate in its opening.
Assembling and Installing Your Gate
STEP 2
Insert the (4) threaded spindle
rods into the holes at each of
the four corners of the gate.
RUBBER FOOT
ADJUSTMENT WHEEL
To Next Page
Loading...
