English 9
STEP 4
When you are satisfied with the general placement of your gate, fully
tighten the threaded spindle rods attached to the lower corners of the gate
by further rotating the adjustment wheels.
Continue by tightening the upper threaded spindle rods. As you tighten the
threaded spindle rods, you will notice the gap between the door frame and the
easy slide latch begin to narrow.
In order for the gate to function properly, stop tightening the upper threaded
spindle rods just before the outer housing of the easy slide latch and the
receiving component touch.
RECEIVING COMPONENT
OUTER HOUSING
NOTE: The gap between the gate and wall should not exceed more than
2.5 inches. Make the appropriate adjustment to ensure you have installed
your gate safely.
To Next Page
Loading...
