PERFORMANCE OPTIONS
Pro-Series units offer
flexibility and versatility. Enjoy
the comfort of a crackling fire
while entertaining (Fast & High
Burn), or set the unit to low and
maintain heat for hours on a
single load (Long & Even Burn).
Fast & High Burn Long & Even Burn
Desired for maximum heat and an
aesthetically pleasing fire
for ambience.
Maintaining a desired long burn and
even heat level. Perfect for overnight
use or while away from the home.
Burn Time
Shorter burn: 3-6 hours Longer burn: 6-14 hours
Temperature
Medium-high output Steady even output
Reloading
More frequent to maintain desired
appearance and ambience
Less frequently; 2-3 times per day
depending on desired heat output
Visual Appearance
Large flickering flames; wood crackling;
fire moves upward through the cata-
lyst near the top front of the unit, and
through the flue
Lower flame height; surface of wood
appears as white ash; fuel ‘bakes’; logs
slowly consume themselves; catalyst
glows red
Log size
Small, medium, large sized pieces of
seasoned wood as required to provide
the desired fire effect
Large, dense, seasoned hardwood logs
deliver best results
Bypass Damper
Closed, after temperature reaches
active zone
(beyond 500º F, 260º C)
Closed, after temperature reaches
active zone
(beyond 500º F, 260º C)
Draft Control
Open (or partially open) to provide
desired results
Closed (or mostly closed)
DID YOU KNOW?
Hardwood will burn for
longer than the equivalent
amount of softwood.
SAFE REMOVAL OF ASHES
Always assume ashes are
still hot, use a steel bucket
for disposal.
WOOD SIZE GUIDE
Kindling Medium Large
Represents approximately
1/2 full load for a Pro-Series insert
FOR BEST RESULTS:
• Use soft wood for Kindling and Medium split logs for a fast burn
• Use seasoned hard wood Large logs for a long burn
(moisture content should be 20% or less)
WHEN RELOADING:
Each time you load fresh wood into the firebox, it is important to rst fully open the bypass damper and the
draft control to prevent smoke from rolling out.
Since reloading causes the unit to drop in temperature allow it to run for 10-15 minutes before closing the
bypass, and a further 10-15 minutes before closing the draft control.
To Previous Page
Loading...
