15
Régul’ Electronique
N2
N3
N1
S
N2
N3
N1
S
STOP
Configuration Consigne Calibration
Chlore
pH
Sel
Temp
Configuration Consigne Calibration
STOP
N2
N3
N1
S
- Adjustment error (ERR REGLAGE)
Levels are not set in ascending order, the levels concerned blink
here, N1 and N2.
- FILLING LEVEL PROBLEM (REMPLISSAGE)
(setting from OFF to 3h-see page 12)
A continuous filling not making it possible to reach the level N2,
exceeding the set time make it possible to detect an excess of
filling.
dEF flashes at the same time as the bar on the faucet to indicate
that the filling is stopped.
To cancel this fault, press and hold the button until it disappears..
- TEMPO RAIN (TEMPO PLUIE)
(setting from OFF to 3h-see page 12)
The level N3 can be reached during a heavy rain,the filtration is
then forced down again below N3 (little chance in case of heavy
rain) the time delay then makes it possible to stop the filtration
force at the end of it in order to return to self filtration mode and
to prevent the filtration pump from continuously operating.
During the delay time, the display shows « force filtration »
At the end of the time delay the display shows RAIN MODE
(MODE PLUIE) until the level drops below level N3 by manual
draining, successive backwashes or after the natural
evaporation of the pool water
To ensure that the filtration restarts automatically it is restarted
for 15 min every 60 minutes.
5- Additional displays
Special cases and anomalies
N2
N3
N1
S
To Next Page
Loading...
Need help?
General