3
Régul’ Electronique
Checks to be carried out before the appliance is switched on
Verification before start-up
- Before starting, it is imperative that you have read all the information
contained in this manual. The records, like the devices, evolve.
Thus the revisions described in the manuals will enable you to know the
perfect functioning and the modifications made.
- The Bulleur must be started when the pool is full and the buffer tank is
at the ideal level.
Technical characteristics
The Bulleur has :
- A senser allowing to measure a heigh of water of 2,50 m
- A measuring rod made up of 3 PVC tubes,20 mm in diameter and 42 cm in length
- If necessary, the measuring rod can be extended by a PVC tube with a diameter of
20mm.
- An intermittent 240 V membrane compressor
- An electronic board protected by a 200 mA fuse
- A 315 mA fuse protection of the solenoid control transformer.
- A led flashes to indicate that it is faulty, preventing the malfunction of the solenoid
valve.
- The 240V- 6 A drain relay is designed to operate a contactor coil and not the direct
control of a power motor.
Fuse 315mA solenoid valve
Led fuse solenoid valve
Contact 6A 240V~
for drain pump contactor
Fuse 500mA alimentation
Fuse 3.15A
Forced filtration
Stop filtration
To Next Page
Loading...
Need help?
General