10
RAUTOOL M1
IMPORTANT NOTES
Always apply clamping tool or
joint at right angles, making sure
it completely contacts entire
surface.
Make sure fitting is correctly
seated in tool. Applying the tool
to the wrong fitting collar will
over-compress the joint.
Note: Never allow fitting
components with a large external
diameter to rest on the jaw teeth,
as this will significantly reduce
the compression contact surface.
Never use damaged expander
head as this will damage the
pipe. Replacements are available
from your local REHAU
representative.
If using an expander bit, make
sure the bit is in the correct
position (completely inserted into
the jaw) before starting tool and
ensure lock screw is tightened.
Check for fit (clamping) before
use to avoid falling out.
Regularly grease the expanding
tool taper using tube of lubricant
supplied with the tool.
Note: Do not apply any grease
to the surface of the expanding
segments that come in contact
with the pipe.
Always insert expanding tool into
pipe as far as it will go.
Do not tilt the expander.
Transition fittings with a large
external diameter must be laid
and compressed on the “free
side.”
NOTICE: Adhere to these instructions to reduce risk of property damage.
To Next Page
Loading...
Need help?
General
