3
RAUTOOL M1
SAFETY INFORMATION
Read
all safety warnings and assembly instructions before using the
tool.
The tool is intended to be used for assembly of SDR11
compression-sleeve fittings in the size range of 25 to 40 mm. Follow
these operating instructions and always keep the safety warnings with
the tool. In addition to the operating instructions, always observe
generally applicable statutory and other binding regulations relating to
the prevention of and protection against accidents.
General Use and Care
–
The tool is suitable for preparation of REHAU compression-sleeve
joints only. Do not use tool for other purposes.
–
Only operate the tool with original REHAU parts and accessories.
–
Maintenance and repair work should be done only in a REHAU
authorized service center. We will not be responsible for any work
performed by an unauthorized person.
NOTICE: To avoid damage to tool, always follow all operating
instructions.
– REHAU will not accept any liability for damage or injury attributable
to unsafe product use, poor maintenance or improper product and
system usage. For technical information, contact your local REHAU
representative or download documents at www.na.rehau.com/
resourcecenter.
CAUTION! Improper handling of the tool may result in personal
injury and/or damage to the tool.
– Do not touch moving parts. Touching moving parts could
cause ngers to become trapped.
– Do not wear loosely tting clothes or jewelry. They may get
caught in moving parts. Wear a hair net if you have long hair.
– Do not work below the minimum processing temperature of
14°F (-10°C). Processing at temperatures under 14°F
(-10°C) or over 113°F (45°C) may result in damage to jointing
components, to the tool and/or in personal injury.
To Next Page
Loading...
Need help?
General
