1. Do not use alcohol, gasoline, kerosene or other corrosive, volatile solvents to clean, otherwise it will seriously
damage the body and internal structure. It is forbidden to use a pressure fun spray and flush. Make sure that
the charging cable is unplugged and the rubber cap has been tightened when cleaning, otherwise it may cause
an electric shock or accident due to water intake.
2. Store you Reid eScooter in a dry and cool room as much as possible to avoid accelerating of ageing. Failure
to do so will reduce the usage life of the battery over time.
3. When the scooter is fully charged and not in use, it needs to be recharged every 3 months to avoid battery
over-discharge protection.
1. Do not use other brand of batteries, otherwise there may be security risks.
2. Do not touch the battery contacts and do not open the battery compartment. Any tampering of this may
cause a short circuit, potentially damaging the battery and causing personal injury.
3. Only use the original charger for charging, otherwise it may cause damage or a fire.
4. Inappropriate disposal of used batteries may result in serious environmental pollution. Disposal of waste
battery packs must be in accordance with local regulations.
Daily Maintenance
If there is a mark on the body of your Reid eScooter, wipe it with a small amount of water with a soft cloth. If it is
difficult to clean, you can use a toothbrush to brush it repeatedly then use a damp cloth to clean in. If the body
has plastic scratches, you can use sandpaper or other abrasive materials for polishing.
Electric scooter cleaning and storage
Note
Electric scooter battery maintenance
5. Do not place the battery in a high temperature environment higher than 50 °C or lower than -20 °C (for
example do not expose the eScooter or its battery pack to the car in summer)otherwise it may cause a
malfunction, or even a risk of fire. The ideal temperature for maximum mileage and performance is between 20°C
and 25°C and riding below 0°C will severely decrease battery life and performance. In some instance, at -20°C
the mileage may be only half or less than at optimal temperature.
Disc brakes debug
Note:
It is forbidden for non-professionals to remove the battery pack. Failure to do so may result in serious electrical
faults or safety short-circuits.
If you feel the brake is tight when you are riding, you can adjust the disc brake by loosening the screw on the
Rotary knob, with a M5 hex wrench (as shown in the picture below). Turn the Rotary knob slightly to the right and
tighten the screw with a M5 hex wrench. If you feel the brake is loose, you can turn the Rotary knob slightly to the
left, after loosening the screw on the Rotary knob with a M5 hex wrench and then tighten the screw.
M5
Rotary knob
Alternatively, take your electric scooter to the nearest service centre for adjustment.
25 26
MAINTAIN ME
To Next Page
Loading...
