3. Fasten the scooter standpipe and fold out the kickstand.
6. After the installation is complete, switch the scooter
on and off to check that the scooter is working properly.
2. Hold the scooter upright, to ensure that the lock will not be affected, please keep the folding-spanner
(the blue part of the image) at the bottom. Pull the folding-spanner to the top, then the scooter is completely locked.
4. Install the handlebar to the standpipe.
5. Use the hex wrench in the tool bag to lock the screws
on both sides.
9 10
BUILD ME
To Next Page
Loading...
