What to do if my Rejuvenation Raven will not start?
If your Rejuvenation Fan isn't starting, there are several potential causes. First, check the main and branch circuit fuses or circuit breakers. Second, examine the line wire connections to the fan and switch wire connections in the switch housings, making sure the main power is turned off. Lastly, if your fan uses a remote, replace the battery in the remote control.
Why is my Rejuvenation Raven so noisy?
A noisy Rejuvenation Fan can be caused by several factors. Check the following: 1. Ensure the blades are properly attached to the fan. 2. Make sure all screws in the motor housing are snug, but not over-tight. 3. Verify that the screws securing the fan blade holders to the motor hub are tight. 4. Confirm that wire connectors inside the switch housing are not rattling against each other or the housing's interior wall, ensuring the main power is off. 5. If you're using a solid-state variable speed control, consider that some fan motors are sensitive to these signals; an alternative control method is recommended. 6. Tighten the screws holding the blades to the blade holders securely.
How to fix a Rejuvenation Raven that wobbles excessively?
Excessive wobbling in your Rejuvenation Fan can be due to several issues: * Ensure the setscrew and nut in the downrod support are tightened securely. * Tighten the setscrew in the downrod/hanger ball assembly. * Make sure the groove hanger ball is lined up with the tab. * Check that the screws securing the fan blade holders to the motor hub are tight. * Verify the fan blade holders seat firmly and uniformly to the motor housing surface; if not, loosen and retighten the screws. * Tighten the hanger bracket screws to the outlet box and secure the outlet box. * Try interchanging the position of fan blades to redistribute weight, for example, exchange blades in positions 1 and 3 or 1 and 4. If this doesn't improve wobble, exchange 2 and 4.
General| Brand | Rejuvenation |
|---|---|
| Model | Raven |
| Category | Fan |
| Language | English |
Describes a 1/2-in.-deep pancake box for mounting outlet boxes.
Describes a 2-1/4-in.-deep box for mounting outlet boxes between joists.
Describes a brace for deep boxes spanning between joists.
Mount the hanger bracket securely to the outlet box.
Make wire connections using supplied connectors as per diagram.
Attach blade holders to fan blades using screws.
Secure blade holders to the fan motor hub using screws and washers.
Connect LED assembly wiring to the motor assembly wiring.
Instructions for synchronizing the remote control with the fan.
Addresses issues where the fan fails to power on.
Helps diagnose and resolve excessive noise from the fan.
Provides solutions for significant fan blade wobble.
To Next Page
