What to do if my Reliable Empressa S550 Iron press doesn't get warm?
If your Reliable Iron press isn't getting warm, it's possible the Automatic Shut-Off has engaged because the pressing plate has been raised for more than 15 minutes without use. To resolve this, simply press the *POWER* button again.
Why is there no steam coming from my Reliable Empressa S550?
If your Reliable Iron isn't producing steam, there are a couple of potential reasons: 1. The water level might be too low. If so, fill the water tank. 2. The controls may not be properly set. If suitable for the fabric, select a higher temperature and wait for the steam ready light to come on. If not, use spray misting bottle as directed.
Why does water drip from the pressing plate of my Reliable Iron?
If water is dripping from the pressing plate of your Reliable Iron, it's likely because the steam button has been pressed for too long. Avoid pressing the steam button for more than 5 seconds continuously.
Why won't the pressing handle move into the automatic maximum pressure position on my Reliable Empressa S550 Iron?
If the pressing handle on your Reliable Iron won't move into the automatic maximum pressure position, it could be that the item on the ironing board is too thick for that pressure. Try using lighter pressure on thicker items and use added steam for wrinkles.
How to open a Reliable Iron Steam Press if the pressing handle is stuck?
If you can't open your Reliable Iron Steam Press using the pressing handle, the locking knob might be in the locked position. Turn the locking knob to the unlocked position.
Essential safety precautions for operating the steam press.
Initial setup steps before turning on the steam press.
Instructions on how to safely fill the water reservoir.
Guide to powering up the steam press and checking indicator lights.
Detailed steps on how to press garments using the steam press.
A chart detailing common issues, their causes, and remedies.
To Next Page
General