Need help?Do you have a question about the Reliance electric GV3000/SE and is the answer not in the manual?
General| Category | AC Drive |
|---|---|
| Output Voltage | 0 to Input Voltage |
| Frequency | 50/60 Hz |
| Control Method | Sensorless Vector Control |
| Communication Protocols | Ethernet/IP, Profibus, DeviceNet |
| Enclosure Type | NEMA 1, NEMA 12 |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Short Circuit, Ground Fault, Overtemperature |
Crucial safety information, warnings, and cautions for installation and operation.
Guidelines for installation to meet CE conformity and EMC directives.
Details on physical layout, enclosure, and available options for the inverter.
Explanation of the inverter's electrical components, power flow, and internal circuitry.
Essential steps and considerations for planning the drive installation.
Identification and wiring of input/output power and external input protection terminals.
Guidelines for wiring practices, signal routing, and transient suppression for the regulator.
Critical safety measures to be followed during maintenance procedures.
Procedure to safely check DC bus voltage before touching internal components.
Steps for checking power unit functions with mains voltage applied or switched off.
Lists of recommended replacement parts for various GV3000/SE inverter types.
Details on line reactor types, part numbers, dimensions, power losses, and weight.
Information on RFI/HF filters, selection criteria, and filter dimensions.
Requirements and guidelines for CE conformity and EMC compliance.
Instructions for wiring motor cables, analog/digital signals, and cabinet configurations.
Mounting and wiring instructions for inverters installed within cabinets.
Technical specifications including input power ratings, DC-bus circuit, and fuses.
Guide for selecting NEMA Design Inverters based on motor requirements.
Overview of the GV3000/SE controller features and performance modes (V/Hz, Vector).
Explanation of parameter lists and organization within the controller software.
Introduction to the keypad functions for display, programming, and control.
Procedures for viewing and changing parameters in the first and second menu lists.
How to select and view drive status and technical data using monitor modes.
Procedure for resetting a flashing fault using the STOP/RESET key.
Steps to access, read, and clear fault codes and timestamps from the error log.
Explanation of parameter types, descriptions, and how to access them.
Parameter to select the drive control source: keypad, terminals, network, or serial.
Parameter to limit motor stator current for protection during acceleration and running.
Parameter to select the drive regulator type: Volts/Hertz or Vector control.
Explanation of how V/Hz control achieves motor speed variation using frequency and voltage.
A comprehensive checklist for safely starting the controller in V/Hz mode.
Essential checks for controller parameters, motor data, and connections before operation.
Overview of closed-loop vector control for AC motors, emphasizing torque and speed regulation.
Parameter to select encoder pulses per revolution or enable sensorless vector control.
Enables the self-tuning procedure to determine motor characteristics for vector control.
Checklist for safely starting the controller in Vector mode, including self-tuning preparation.
Reference for Regulator card stock numbers and other spare parts information.
Guide to identifying and resolving alarms, faults, and fatal fault codes.
Table listing fault codes, possible causes, and corrective actions.
Information on fatal fault codes, their causes, and reset procedures.
Quick reference for general parameters, including selection and adjustment ranges.
Quick reference for V/Hz mode specific parameters.
Quick reference for Vector mode specific parameters.
To Next Page
