Reliance electric PSC7000

Other manuals for Reliance electric PSC7000

Instruction Manual68 pages

Questions and Answers

K
Kristen PerryAug 11, 2025
What to do if BAT.OK lamp is off on Reliance Electric Controller?
- K
  Kristi WilsonAug 11, 2025
  If the BAT.OK lamp is off on your Reliance Electric Controller, it could be due to several reasons: * The battery voltage might be lower than 2.7V. Ensure the battery is connected to the DSP module. * The installed battery may not be properly connected to the DSP module. Replace the battery of the DSP module. * A hardware failure might have occurred. If a PSC Control Card reset doesn't work, replace the PSC7000 Control Card.
M
megan23Aug 27, 2025
Why is BAT.OK lamp blinking on Reliance Electric Controller?
- E
  egoodwinAug 27, 2025
  If the BAT.OK lamp is blinking on your Reliance Electric Controller, it means the battery voltage is falling to the regular voltage (below 2.9V). Replace the battery of the DSP module.
R
Rebecca PriceSep 10, 2025
How to fix CPU OK lamp when it is off on Reliance Electric Controller?
- W
  William SmithSep 12, 2025
  If the CPU OK lamp is off on your Reliance Electric Controller, it could indicate a hardware failure. First, make sure that power is supplied to the PSC Control Card. Second, check that the PSC7000 Control Card and power supply are securely mounted into the PSC backplane. If resetting the PSC Control Card doesn't resolve the issue, consider replacing the PSC7000 Control Card.
J
Joshua PetersonNov 3, 2025
What to do if autorun is not working on Reliance Electric Controller?
- N
  Nicholas KirkNov 3, 2025
  If the Autorun is not working on your Reliance Electric Controller, it could be due to the PSC7000 having just completed an auto reset after a bus error, or a hardware failure. Here's what you can do: 1. Check if the system variable (AutorunPermission@) is FALSE. If so, and when it should be TRUE, turn on the PSC7000 Control Card. 2. Reset the error on the PSC terminal or perform a download from CF. This should make AutorunPermission@ TRUE, enabling autorun. Note that downloading from the PSC terminal won't work. 3. With the system switch in the neutral (Enable) position, ensure the system variable (AUTORUN@@) is TRUE. If it's FALSE, replace the motherboard of the PSC7000 Control Card. 4. If the PSC7000 Control Card isn't activated when power is turned off and on again, replace the DS...