ReliOn WMTBPA-845 - User Manual

Questions and Answers

L
Lisa SpencerAug 12, 2025
What to do if my ReliOn WMTBPA-845 displays the E3 error?
- T
  thomas62Aug 12, 2025
  If your ReliOn Blood Pressure Monitor displays the E3 error symbol, it means there was an error determining measurement data. Try measuring again.
B
Brandon EllisAug 15, 2025
Why does my ReliOn WMTBPA-845 show high or low values?
- A
  ashley63Aug 15, 2025
  Blood pressure constantly varies based on many factors such as stress, time of day, and how you wrap the cuff. Please review the “Before Taking a Measurement” and “Taking a Measurement” sections for guidance.
E
Eric RomeroAug 19, 2025
Why my ReliOn Blood Pressure Monitor does not turn on?
- A
  adamdelgadoAug 19, 2025
  If your ReliOn Blood Pressure Monitor does not turn on when you push the START/STOP button, the batteries may be dead. Replace them with four new "AA" alkaline batteries. Also, check that the battery polarities are correct when you insert them.
R
Roberto NicholsAug 23, 2025
What to do if my ReliOn Blood Pressure Monitor displays the EE error?
- M
  Mrs. Maria Cooper DDSAug 23, 2025
  If your ReliOn Blood Pressure Monitor displays the EE error symbol or shows a blood pressure value that seems too low or too high, it might be due to incorrect cuff placement. Make sure you wrap the cuff properly so that it's positioned correctly. Also, avoid talking or moving during the measurement; keep your arm steady and try measuring again. Shaking your arm with the cuff on can also cause this error.
T
Tammy WalkerAug 27, 2025
What to do if my ReliOn Blood Pressure Monitor displays the E1 error?
- J
  Jade JonesAug 27, 2025
  If your ReliOn Blood Pressure Monitor displays the E1 error symbol, it indicates an air circuit abnormality. This could be because the cuff tube isn't properly plugged into the monitor. Check the cuff connection and then measure again.
C
campbellmarcusAug 30, 2025
What to do if my ReliOn Blood Pressure Monitor displays the E2 error?
- A
  Anthony ChoiAug 31, 2025
  If your ReliOn Blood Pressure Monitor displays the E2 error symbol, it means the inflation pressure exceeded 300 mmHg. Switch the unit off and then measure again.
J
Jennifer NavarroSep 3, 2025
What to do if my ReliOn WMTBPA-845 Blood Pressure Monitor displays the EP error?
- J
  Jose HortonSep 3, 2025
  If your ReliOn Blood Pressure Monitor displays the EP error symbol, it indicates a system error. Try measuring again.
A
andrew16Sep 7, 2025
What to do if my ReliOn Blood Pressure Monitor has no power?
- A
  Amanda LopezSep 7, 2025
  If your ReliOn Blood Pressure Monitor has no power and no display appears, replace all four batteries with new ones. Also, check that the battery polarities are correctly aligned during installation.