To Next PageTo Next PageWhy is there no sound from my Reloop RMP-2.5 alpha Media Player?
If you're not getting any sound from your Reloop Media Player, the output cable might be connected incorrectly or not at all. Also, check the operation of your amplifier or mixing console. Make sure the output cords are properly connected and that your amplifier and mixer are correctly set up.
What to do if my Reloop RMP-2.5 alpha CD is skipping?
If the CD is skipping, it may be because the CD player is experiencing continuous vibrations and shocks for more than 10 seconds. Try installing your system in a different location to avoid these disturbances.
How to fix humming noise from Reloop RMP-2.5 alpha Media Player?
A humming noise from your Reloop Media Player is likely due to loose cable connections. Check all the sound plugs to ensure they are securely connected.
What to do if my Reloop Media Player CD does not start playback?
If the CD doesn't start playing, it might be inserted upside down or is dirty. Ensure the CD is inserted with the label facing upward and clean the CD.
Why is there no power when activating the ON/OFF button on my Reloop RMP-2.5 alpha?
If your Reloop Media Player isn't powering on, it might be due to a poor mains plug connection. Check to ensure the mains plug is properly connected.
General| Product color | Black |
|---|---|
| Volume control | Rotary |
| Audio formats supported | MP3, WAV |
| Video formats supported | - |
| Built-in storage media | No |
| Card reader integrated | Yes |
| Total storage capacity | - GB |
| Frequency range | 17 - 20000 Hz |
| Channel separation | 83 dB |
| Audio output channels | - channels |
| Signal-to-Noise Ratio (SNR) | 90 dB |
| USB 2.0 ports quantity | 1 |
| Component video (YPbPr/YCbCr) out | 0 |
| AC input voltage | 100-240 V |
| AC input frequency | 50 - 60 Hz |
| Power consumption (typical) | 12 W |
Weight and Dimensions| Depth | 340 mm |
|---|---|
| Width | 322 mm |
| Height | 112.6 mm |
| Weight | 3600 g |
General safety warnings, handling precautions, and prohibitions on device modification.
Connecting outputs, power, headphones, and initial device setup.
Using Play/Pause, Cue buttons, and Track Encoder for basic playback.
Switching to MIDI mode, controlling decks, Bank Program, Shift, and Jog Wheel MIDI functions.
Connecting players via USB for audio linking and using the Database Builder software.
