REMEHA Avanta Series User Manual

User Guide
Remeha Avanta Range
12v | 18v | 24v
Please ensure that the installer has fully completed the Benchmark Checklist on the inside
back pages of the installation instructions supplied with the product and that you have signed
it to say that you have received a full and clear explanation of its operation. The installer is
legally required to complete a commissioning checklist as a means of complying with the
appropriate Building Regulations (England and Wales).
All installations must be notified to Local Area Building Control either directly or through
a Competent Persons Scheme. A Building Regulations Compliance Certificate will then
be issued to the customer who should, on receipt, write the Notification Number on the
Benchmark Checklist.
This product should be serviced regularly to optimise its safety, efficiency and performance.
The service engineer should complete the relevant Service Record on the Benchmark
Checklist after each service.
The Benchmark Checklist may be required in the event of any warranty work and as
supporting documentation relating to home improvements in the optional documents section
of the Home Information Pack.
Broag Ltd.
Remeha House
Molly Millars Lane
RG41 2QP WOKINGHAM,
Berks.
Tel: +44 118 9783434
Fax: +44 118 9786977
Internet: uk.remeha.com
www.avantarange.com
E-mail: boilers@broag-remeha.com
© Copyright
All technical and technological information contained in these
technical instructions, as well as any drawings and technical
descriptions furnished by us remain our property and may not be
multiplied without our prior consent in writing.
120578.indd 1 6-3-2009 14:45:49

REMEHA Avanta Series Specifications

General

Model	Avanta Series
Category	Boiler
Installation	Wall-mounted
Heat Exchanger Material	Stainless Steel
Type	Condensing
Fuel	Natural Gas
Boiler Type	Combi

Summary

Short User Guide Safety

Safety Instructions

Covers critical safety advice for gas leaks, smoke, installation location, and temperature settings.

Boiler and Heating System Problems

User-Resolvable Error Codes

Details error codes that users can potentially resolve and the steps to take for each.

Installer-Remedied Error Codes

Advises users to contact an installer for unlisted error codes or water leaks.

Changing Boiler Settings

Central Heating Flow Temperature

Guide on adjusting the P1 setting for the central heating water flow temperature.

Domestic Hot Water Temperature

Instructions on changing the P2 setting for domestic hot water temperature.

Boiler Regulation Mode

Procedure for modifying the P3 setting to control central heating and hot water modes.

Eco or Comfort Mode

Details on adjusting the P4 setting to select between Eco and Comfort modes.

Display On/Off Setting

Instructions for changing the P6 setting to control the display's on/off behavior.

Disabling the Boiler

Long-Term Non-Use

Guidance on disabling the boiler for extended periods, with or without frost protection.