REMEHA Avanta Range 24c User Manual

User Guide
Remeha Avanta Range
24c | 28c | 35c | 39c | 18s | 24s | 30s
Please ensure that the installer has fully completed the Benchmark Checklist on the inside
back pages of the installation instructions supplied with the product and that you have signed
it to say that you have received a full and clear explanation of its operation. The installer is
legally required to complete a commissioning checklist as a means of complying with the
appropriate Building Regulations (England and Wales).
All installations must be notified to Local Area Building Control either directly or through
a Competent Persons Scheme. A Building Regulations Compliance Certificate will then
be issued to the customer who should, on receipt, write the Notification Number on the
Benchmark Checklist.
This product should be serviced regularly to optimise its safety, efficiency and performance.
The service engineer should complete the relevant Service Record on the Benchmark
Checklist after each service.
The Benchmark Checklist may be required in the event of any warranty work and as
supporting documentation relating to home improvements in the optional documents section
of the Home Information Pack.
Broag Ltd.
Remeha House
Molly Millars Lane
RG41 2QP WOKINGHAM,
Berks.
Tel: +44 118 9783434
Fax: +44 118 9786977
Internet: uk.remeha.com
www.avantarange.com
E-mail: boilers@broag-remeha.com
© Copyright
All technical and technological information contained in these
technical instructions, as well as any drawings and technical
descriptions furnished by us remain our property and may not be
multiplied without our prior consent in writing.
120578-160109
1
2
0
2
2
5
0
0
7
5
5
8
77
120578.indd 1120578.indd 1 6-3-2009 14:45:496-3-2009 14:45:49

REMEHA Avanta Range 24c Specifications

General

Brand	REMEHA
Model	Avanta Range 24c
Category	Boiler
Language	English

Summary

Remeha Avanta Range User Guide

Benchmark Checklist Compliance

Guidance on installer completion and customer receipt of the Benchmark Checklist for regulatory compliance.

Remeha Avanta Plus Safety Information

Gas and Smoke Detection Procedures

Actions to take if gas or smoke is detected, including evacuation and contacting services.

Installation Location and Temperature Safety

Requirements for boiler installation location and water/pipe temperature limits for safe operation.

Remeha Avanta Plus Boiler Troubleshooting

User-Resolvable Error Codes

Troubleshooting common error codes that can be addressed by the user following specific steps.

Installer-Remedied Error Codes

Error codes requiring professional intervention by a qualified installer.

Remeha Avanta Plus Settings Adjustment

P1: Central Heating Flow Temperature

Procedure to adjust the flow temperature for the central heating system.

P2: Domestic Hot Water Temperature

Procedure to adjust the temperature for domestic hot water supply.

P3: Boiler Regulation Modes

Setting boiler operation for DHW only, CH only, or both.

P4: Eco vs. Comfort Mode

Switching between energy-saving (Eco) and normal (Comfort) operating modes.

P6: Display On/Off Functionality

Configuring the boiler display to remain on or turn off automatically.

Remeha Avanta Plus Boiler Disabling

Disabling for Frost Protection

Steps to disable the boiler to prevent freezing during periods of non-use or holidays.