5
Setting Cutting Length
12 12 mm
14 14 mm
16 16 mm
18 18 mm
Note: trimmer comb must be attached to the product in order to use the hair length
selector.
TO THIN AND TAPER THE BEARD/MOUSTACHE
1. Fit the adjustable comb.
2. Use the zoom wheel to set the comb to the desired length setting.
3. The setting will appear on the length position indicator. If you are trimming for the
rst time start with the maximum trimming length setting.
4. Turn the unit on.
5. Place the at top of the trimmer comb against the skin.
6. Slowly slide through the hair. Repeat from dierent directions as necessary.
7. If hair builds up in the trimmer comb during the trimming process, switch the unit
o, pull the comb and brush the hair o.
Note: Use the beard trimmer without the adjustable comb for trimming hair close to the
skin. This will trim hair to 1mm, holding the blades perpendicular to the skin will trim hair
to 0.4mm.
TRIMMING THE NAPE OF YOUR NECK
Note: you will need a hand mirror for this operation if performing it alone.
1. Remove the adjustable comb.
2. Use your ngers to lift the hair at the base of your head up o the neck. Your index
nger should be covering the roots of the hairs you are lifting to prevent accidental
removal by the beard trimmer.
3. Using your other hand, hold the trimmer to the base of your neck with the cutting
unit facing up and move the trimmer up the length of the neck until it touches your
nger covering the hair roots at the base of your head.
4. Be sure to move the unit slowly when performing this operation and to keep the
roots at the base of your head out of the way of the trimmer.
TO DEFINE THE BEARD/MOUSTACHE LINE
1. Hold the trimmer with the trimmer blade facing you.
2. Start with the edge of beard/moustache line and gently lower the trimmer blade
onto your skin.
3. Use motions towards the edge of the beard/moustache line to trim to desired
locations in facial area and away from beard in neck area.
To Next Page
Loading...
