EasyManua.ls Logo

Remington HC7500AU - Battery Removal and Disposal

Remington HC7500AU
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
Suitable for use in bath and shower.
This product conforms to radio frequency interference requirements.
Any product purchased and used commercially carries a limited 90 Day Warranty.
BATTERY REMOVAL
We strongly recommend that a professional removes the rechargeable
battery. Parts of the shaver case, and tools have sharp edges and may
cause injury if not handled correctly.
The rechargeable battery must be removed from the appliance before
it is scrapped.
Disconnect the charging adapter before removing the battery.
1. Ensure the device is discharged of all power. To do this, switch it on
and allow it to run until it stops.
2. Remove the head assembly by pulling it off.
3. Using a small screwdriver, pry the front panel off the handle.
4. Pry off then remove the two side panels.
5. Using a small flat screwdriver, pry off the display panel.
6. Unscrew the 4 screws and open the front housing.
7. Unscrew the 4 screws and remove the rear housing.
8. Pry the battery from the circuit board.
9. Disconnect the battery from the two connection wires.
The battery is to be disposed of safely.
Do not attempt to operate the shaver once you have opened it.
Legislation in some localities mandates that e-waste (anything with a plug,
battery or cord) is disposed of through controlled recycling facilities and
must not be disposed of in general household waste. For more information
about recycling of electrical and battery operated appliances, please
contact your local council or your local household waste disposal service.

Related product manuals