6
Once fully charged, all 4 lights will stay on for 5 minutes and then go off.
Charge remaining
Aftre use, when you switch off your shaver, the charging indicator lights
show the remaining charge for 5 seconds.
Lights Charge remaining
99-75%
75-50%
25-50%
25% or less
DURING USE
The lights will illuminate backwards and forwards during use in a cycling
pattern.
• Your head shaver cannot be used when it is charging.
• When empty, the battery should be charged for 2 hours for a full
charge and will provide up to 60 minutes of shaving time.
• To preserve the life of the battery do not charge the battery after each
use. The best practice is to use the shaver until there is only a single
light left flashing and then recharge.
Note: Some countries will require the use of a plug adaptor that is not
included with your shaver.
SHAVING YOUR HEAD
1. Hold the head shaver body in the palm of your hand. Press the On / Off
switch to turn the head shaver on.
2. Press the five cutting heads against your scalp. It is not necessary
to press hard to shave. Pressing hard does not cut closer and could
increase irritation. The cutting head will flex to follow the contours of
your head.
3. Move the shaver slowly around your head. You may use linear strokes,
or rotating motion, whichever you feel is most effective picking up and
cutting your hair.
4. Use a hand held mirror to check the back of your head to confirm a
complete and thorough shave. You may also use your other hand to
feel for complete and consistent cutting.
5. It is not recommended to use the head shaver for facial hair.
6. When finished turn the shaver off.
To Next Page
Loading...
