Cleaning
Your Device
■ Do not depilate (waxing, plucking, threading or creams) during the treatment
– shaving is acceptable as long as you avoid shaving 24 hours after each
treatment.
■ Do not use bleaching creams or perfumed products for 24 hours after
treatment.
■ Do not scratch or pick at the treated area.
Cleaning Your i-Light Device
CAUTION: Before cleaning your i-Light device, make sure that the power switch is OFF and the
power cord is disconnected from the base unit.
■ Regular cleaning helps to ensure optimal results and a long life for the i-Light
device. The exterior surface of the base unit and hand piece may be wiped
clean with a slightly damp cloth.
■ To clean the Flash Window, use only the lint-free cloth included with your
i-Light device. Take care not to scratch or chip the Flash Window. Scratches
and chips can reduce the effectiveness of the unit.
■ For stubborn stains, use a dampened cotton swab to apply a small amount
of water to the Flash Window and clean with the lint-free cloth provided.
■ Use a small hand-held vacuum to remove dust and debris from the hand
piece vents.
WARNING: If the Flash Window is cracked or broken, the unit must not be used.
Never scratch the filter glass or the metallic surface inside the Nose
Cone.
CAUTION: The i-Light is a high voltage device. Never immerse in water. Never clean
the unit or any of its parts under the tap or in the dishwasher.
Do not use petroleum-based or flammable cleaning agents because of
the risk of fire. Never use scouring pads, abrasive cleaning agents or
aggressive liquids such as oil or acetone to clean the unit.
To Next Page
Loading...
