Remington MB4850 - Getting Started and Usage; Charge Level Indicators; Operating Modes

4
C GETTING STARTED
• Note: It is recommended to fully charge your appliance before using for the
rst time. Please refer to the charge times shown in this book.
• Ensure the product is switched o.
• The adaptor automatically adjusts to a main voltage between 100V and
240V.
• Connect the product to the adaptor and then to the mains.
, Charge Level Indicators
Charge Level Indicator
Charging Blue LED will ash
Empty Red LED will ash
Fully Charged Blue LED will remain on
• Run time from fully charged is up to 120 minutes.
• Charge time from empty is 4 hours.
, Note: To preserve the life of your batteries, let them run out every 6 months
then fully charge.
F INSTRUCTIONS FOR USE
• Forcordeduseconnecttheproducttotheadaptor,thentothemains.
Extended mains only use will result in a reduction of battery life.
• Cordlessuse–whentheproductisswitchedonandfullychargeditcanbe
used in cordless mode for up to 120 minutes.
• Switchtheproductonbyslidinguptheon/offswitch.
• Alwayscombyourbeardormoustachewithafinecombbeforeyoustart
trimming.
• Toattachtheadjustablecomb,firstensuretheadjustablezoomwheelisset
to 1. Then slide on the desired comb so that the comb rails align into the slots
found at the top of the trimmer head.
• Selectthecomblengthbyrotatingthezoomwheelupwardstoincreasethe
length and downwards to decrease the length. Please see the table below for
the different length increments.