4
INSERTING THE BATTERY
Your Remington
®
Groom & Go trimmer is powered by one “AA” ALKALINE battery,
(battery not included).
1. To open the battery compartment, turn the base of the unit approximately
1cm clockwise (to the right) and pull it off.
2. Insert the battery into the unit, positive end first.
3. Replace the base and turn it 1cm anti-clockwise (to the left) to lock it in place.
BATTERY CAUTIONS
• Using non-alkaline batteries will impair the unit’s operating performance.
• The battery should not be left in the unit if it is not in use for long periods.
• To prevent battery corrosion, the unit should be stored in a dry environment.
• Dead batteries should be removed immediately and disposed of properly.
• Do not use rechargeable batteries with this appliance. The lower voltage in
rechargeable batteries impairs the performance of the cutting unit.
HOW TO USE
Changing the Attachment Heads
This model comes with interchangeable attachments. You may want to use the
rotary head to trim hairs from the nose & ear, and the detail trimmer for sideburn
hairs.
To change heads:
1. Turn the trimmer off.
2. Detach the cutting head by turning it counter-clockwise to the unlocked
position and pulling it off.
3. Once the previous head is removed, attach the other head by placing it on top
of the unit and turning it clockwise to the locked position.
To remove hair from the nose
1. Select the nose & ear trimmer.
2. Turn the trimmer on.
3. Insert the trimmer’s cutting unit gently into the nostril.
4. Rotate the trimmer in a circular motion around the opening of the nostril.
5. For best cutting efficiency, gently move trimmer in and out of the nostril as
you rotate the trimmer.
6. Do not insert the trimmer more than 6mm into your nostril.
To Next Page
Loading...
