8
4. Move your trimmer slowly and keep the hair roots at the base of your head out of the
way of the trimmer.
HAIR CLIPPING
Step 1: Nape of the neck
• Attach the 3mm or 6mm fixed comb.
• Hold the trimmer with the blade teeth pointing upwards. Start at the centre of the
head at the base of the neck.
• Slowly lift the trimmer, working upwards and outwards through the hair trimming
just a little at a time.
Step 2: Back of the head
• With the 12mm or 15mm guide comb attached, cut the hair at the back of the head.
Step 3: Side of the head
• With the 3mm or 6mm guide comb attached, trim sideburns. Then change to the
longer 9mm guide comb and continue to cut the top of the head.
Step 4: Top of the head
• Use the longer length fixed combs to cut hair on top of the head against the
direction in which the hair normally grows.
• Always work from the back of the head.
Step 5: The finishing touches
• Use the trimmer without a comb for close trimming around the base and sides of the
neck.
• To produce a clean straight line at the sideburns, place the trimmer at right angles to
the head, tips of the blades lightly touching the skin and then work downwards.
USING THE FOIL SHAVER
• Fit the foil shaver attachment.
• Use short, well-controlled linear movements. Use your free hand to stretch your skin.
This encourages the hair to stand upright, making it easier to shave.
• Note: always trim your facial hair before shaving.
CLEANING AND MAINTENANCE
Care for your appliance to ensure a long lasting performance. We recommend that you
clean it after each use.
AFTER EACH USE
• Brush any accumulated hairs from the trimmer and attachment heads.
• The easiest and most hygienic way to clean the trimmer is under the tap.
To Next Page