6
ENGLISH
TRIMMING
• Slide the trimmer button to release the detail trimmer.
• Hold the trimmer at a right angle to your skin.
• Place the trimmer at desired trim line for a quick, easy, professional trim.
• To retract the trimmer, push down until it locks into position.
STUBBLE LOOK
• Fit the stubble head guard to your shaver for a 3-day stubble look.
TIPS FOR BEST RESULTS
• Always hold the shaver at right angles to the skin so that all three heads are touching
the skin with equal pressure.
• Use moderate to slow stroking movements. The use of short circular motions in
stubborn areas may obtain a closer shave, especially along the neck and chin line.
• DO NOT press hard against the skin in order to avoid damage to the rotary heads.
S
CARE FOR YOUR SHAVER
• Care for your appliance to ensure a long lasting performance. We recommend you
clean your appliance after each use.
• Ensure the appliance is switched o and unplugged from the mains before cleaning.
1. Open the shaver head by pressing the release button (Fig. A).
2. Empty out any hair clippings.
3. Pull the shaver head upwards to remove it from the body (Fig. B).
4. Locate the centre arrow and slide the retainer in the opposite direction to release it.
Once released, lift it out of the shaver head (Fig. C). Make a note of the correct
orientation of the retainer to make retting easier.
5. Carefully brush away any hairs from the cutters.
6. For a more thorough cleaning, lift out the three cutters (Fig. D).
7. Wash the shaving head under running water (Fig. E). Allow to dry thoroughly.
8. Carefully ret the three cutters.
9. Ret the retainer. Locate the centre arrow and slide the retainer in the same direction
as the arrow until it clicks into place (Fig. F).
10. Once the shaver head is assembled, align the spring hinge with the slot at the back of
the hair pocket and press into place (Fig. G). Snap the head assembly closed.
TRIMMER
Lubricate the teeth of the trimmer every six months with a drop of sewing machine oil.
7 / 106
To Next Page
Loading...
