Remington RM1035P User Manual

15
STARTING AND STOPPING
WARNING:
Never operate the unit without the guide bar
and saw chain properly installed. Make sure the guide bar
cover is securely assembled. Make sure the saw chain is
properly tensioned. Refer to Adjusting the Chain Tension
instructions in the Maintenance section.
STARTING INSTRUCTIONS
NOTE: To help prevent the motor from starting accidentally, this unit
has a trigger lockout. The trigger lockout and trigger must both
be engaged to start the unit.
1. Press and hold the trigger lockout (Fig. 6).
2. Continue to hold the trigger lockout. Squeeze and hold the
trigger to start the unit (Fig. 6).
3. Release the trigger lockout, but continue to squeeze the trigger.
WARNING:
The saw chain will spin after the unit starts.
Keep hands and feet clear of the saw chain and do not
allow the saw chain to contact any object(s).
STOPPING INSTRUCTIONS
1. Release the trigger and wait for all moving parts to come to a
complete stop (Fig. 6).
NOTE: Upon release of the trigger, the trigger lockout will reset to
the locked position.
Fig. 6
Trigger
Trigger Lockout
BEFORE STARTING THE UNIT
1. Fill the chain oil reservoir with bar and chain oil. Refer to Adding
Bar and Chain Oil in the Maintenance section.
2. Connect the power cord to an appropriate extension cord.
Connect the extension cord to an appropriate power outlet.
Refer to Connecting and Disconnecting the Power Source.

Remington RM1035P Specifications

General

Brand	Remington
Model	RM1035P
Category	Pole Saw
Language	English