Need help?Do you have a question about the REMKO VRS Series and is the answer not in the manual?
Details the unit's design, operation, typical places for use, and intended industrial/commercial use.
Explains operational modes, automatic controls, and safety mechanisms.
Guidelines for choosing a location and ensuring adequate combustion air supply.
Covers ground, outside, wall, suspended assembly, general steps, and fuel connection.
Instructions for gas supply, burner fitting, electrical wiring, and thermostat connection.
Instructions for exhaust system installation, permits, and configurations.
Checks for fan motor, drive tension, current measurement, and thermal overcurrent relay.
Steps to start the unit for heating or ventilation.
Procedure for safely turning off the unit and its cool-down phase.
Instructions for cleaning components and general servicing recommendations.
Information on warranty validity, service, and guarantee policy.
Detailed steps for cleaning the unit's internal components for VRS 20 INOX.
Alternative cleaning procedure for VRS B and INOX units.
Addresses unit start failures, fan issues, and burner problems with troubleshooting steps.
Detailed technical specifications for VRS INOX models.
Detailed technical specifications for VRS B models.
Electrical schematics for VRS 20 INOX, 230V, and 400V models.
Specific electrical diagram for the fan motor.
Visual breakdown and parts list for VRS 20 INOX.
Visual breakdown and parts list for VRS INOX.
Visual breakdown and parts list for VRS B.
Physical dimensions of VRS INOX models in various configurations.
Physical dimensions of VRS B models in various configurations.
General| Overheat protection | Yes |
|---|---|
| Type | Electric Heater |
| Power consumption | 2000 W |
| Heating capacity | 2000 W |
| Thermostat | Adjustable |
| Fan speed settings | 2 |
To Next Page
