Need help?Do you have a question about the REMKO GPS Series and is the answer not in the manual?
Explains how to interpret LED signals for error codes and perform resets.
Lists common error codes (F1, F2, F5, F6, F8) and their associated malfunctions.
Details requirements for connection by authorised technicians, shut-off switch, and wiring.
Explains connection to thermostats, timers, or controllers for unit operation.
Explains the functions and connection of the ATR-10 controller.
Covers installation by authorised technicians, ductwork, pressure, and connections.
Lists checks for connections, polarity, grounding, and burner startup.
Guides on performing combustion analysis and checking CO2 values.
Details adjustments for CO2 levels and offset regulation using screws.
Lists checks for electrodes, lines, Venturi tube, heat exchanger, gas pressure.
Details cleaning and positioning of electrodes and inspection of lines.
Explains how to check ionisation current and safety thermostat function.
Provides steps for replacing the GPS unit's control board.
Details the process of converting from natural gas to liquid gas and required checks.
Provides a flowchart for diagnosing operational issues and unit blockages.
Lists specific error codes (F1, F2, F5, F6, F8) and their associated malfunctions.
Lists nominal thermal load, heat capacity, airflow, and temperature increase.
To Next Page
General
