REMKO GPS Series User Manual

6
REMKO GPS series
the cable passages for the electrical lines as well as
the plug connection for the power supply. In the right-
hand side section the necessary components for the
control and safety are found behind the inspection
door, including e.g.:
- the electrical circuitry with the cabling
- the control electronics
- the gas valve
- the modulating gas burner
In the interior of the unit, directly in the circulation air
flow, is the combustion chamber with heat exchanger.
The combustion chamber is manufactured entirely
from Inox stainless steel, AISI 430. For the purpose
of higher resistance to corrosion from damp vapours,
Inox stainless steel, AISI 441 is used for the heat
exchanger.
The special form and the large surface area
of the combustion chamber and heat exchanger
guarantee a high level of efficiency and long service
life.
The gas burner is likewise manufactured entirely from
special, mechanically-processed stainless steel.
Function of the units
The 2-stage gas wall heaters of the GPS series have
been developed for the heating of industrial and
commercial spaces.
The electronic control of the unit regulates the heat
output between minimum and high-output according
to the set NTC1 temperature.
With the pre-mix and modulation technology,
efficiency of up to 94% can be achieved.
The nominal heating capacity of the REMKO GPS
series lies between 13.0 and 73.5 kW.
The units consist primarily of the combustion chamber
with heat exchanger and the fan(s).
The ambient air is suctioned in by the fan(s) and
efficiently channelled through the combustion
chamber with heat exchanger. The combustion
chamber is heated by the gas burner operation and
releases its heat to the air flowing past. The air heated
in this manner is blown out of the front side
of the unit through an adjustable outlet grid.
Operation of the unit as intended is only possible
with a connected temperature controller, e.g. ATR-10
(accessory).
Unit description
Definition of the unit
Pursuant to EU Directives, the unit is defined as:
"Gas fan-assisted heater (WLE) without flow-
operated safety device, equipped with a fan in front
of the heat exchanger".
The unit is a fully-automatic, directly-fired fan-assisted
air heater for wall and ceiling installation.
It can be fuelled with natural gas or liquid gas.
The unit is used for continuous and temporary
heating of open and closed spaces, e.g. in:
halls, workshops,
greenhouses,
storage rooms, etc.
Classification of the units
The units have been classified by the European
standardised
regulations EN 437 and EN 1020 according to:
The gas category:
determination according to the type of gases with
which they may be operated.
For Germany DE II2ELL3B/P
The gas type:
the burner can be operated with gases of the second
family (natural gas - group H and L) and with gases
of the third family (butane and propane).
The type of gas fireplace:
differentiation according to the possibilities
of the discharge of the combustion products
or the supply of the combustion air.
(ambient-air-dependent/independent)
Additional notes can be found in the chapter
"Installation of the flue gas evacuation and
the combustion air supply".
Design of the units
The exterior cladding of the units is made from coated
steel sheet, which guarantees durability.
The outlet grid is found in the front section.
In order to ensure an optimal distribution of warm
air in the installation location, the horizontal fins of
the outlet grid can be manually adjusted. On the rear
side of the unit you will find the fan(s) with protection
grid, the connection nozzles for the removal of
the flue gas and supply of the combustion air, the gas
connection nozzles,

REMKO GPS Series Specifications

General

Brand	REMKO
Model	GPS Series
Category	Heater
Language	English