REMKO GPS Series User Manual

34
REMKO GPS series
Fault-finding
Troubleshooting
We reserve the right to modify the dimensions and design as part of the ongoing technical development process.
Operation
Wall-mounted heater
REMKO GPS
Check power supply
of the unit
Unit is blocked
Hold the RESET key
down for longer than
5 seconds
Error is displayed on
the basis of a flashing
code
See error number and
error
Heat output
insufficient
Check whether
the internal controller is
set for the high or low
flame 2 K over the desired
room temperature
Operation
normal
Is the burner
switched on?
Is the expelled air
warm?
Is the
burner running at
maximum
output
Does the green
operating light
illuminate
Does the red
error indicator
light illuminate?
NO
NO
YES
NO
YES
YES
YES
YES
NO
Cable OK after
visual inspection?
NO
Cable defective
YES
Board defective
Operating light
defective
NO

REMKO GPS Series Specifications

General

Brand	REMKO
Model	GPS Series
Category	Heater
Language	English