Rev. 02 – July 16
th
, 2009
7 Normal Procedures
Normal Procedures 7 - 11
7.15 T/O and Landing with Constant Speed Prop
There are no differences for take off and landing procedures with a
constant speed propeller and a fixed pitch propeller. However,
please notice the following features:
Take-Off procedures:
1. Set engine speed on prop controller to 5.600 rpm
2. Climb with 5.600rpm until cruising altitude is established, but
not longer than 5min. In this case reduce engine speed to
5.500 rpm or lower.
3. For cruise select power setting according to table named
above
Approach/Landing procedures:
1. For descent and approach, reduce engine speed as required
2. On final approach select 5.600 rpm
Note:
Do not exceed the maximum engine speed!!!
To Next Page
Loading...
