7
5. Trouble Shooting Guide
4. Firmware Upgrade
1. If “No rmware to update” message appears after rmware
update,
Solution: Connect your device to a PC and delete all les stored
in the storage. Then copy the .bin rmware le to the memory
and reboot.
2. If “Low rmware versions” message appears after rmware
update,
Solution: Connect your device to a PC and delete all les in the
storage. Reboot to check the version of the rmware.
3. If you can’t see your on the camera network list,
Solution: In order to establish Wi-Fi connection between R1+
and GoPro, the GoPro needs to have its SSID. The SSID can be
generated through the GoPro App. Before using with R1+, please
establish connection between GoPro HERO4 and GoPro App to
generate the SSID.
4. If the diplay gets darker or backlight goes off,
Solution: It means that the battery is running low, so please
recharge the device.
5. If your device freezes while using,
Solution: Press the reset button located next to the charging
port. If the problem persists, please constact customer support.
6. If the device does not boot, or shuts down automatically
while booting,
Solution: Please connect your device to your PC, and have all
les deleted in the storage. If there aren’t any les, please con-
tact customer support.
Please visit our website at www.removu.com/rmware to get
the latest rmware. The detailed upgrade instructions can also be
found on the page.
To Next Page
Loading...
